The "Condor Extreme" low pressure, plural component pump system is fully heated and has been specifically developed to maintain material temperatures in the 125° F to 150° F range. Standard on this model is 30 feet of Insulated heated lines and heated 7-gallon stainless steel tanks. This pump was initially engineered for use in the elastomer casting industry, for the production of urethane and hybrid urethane/polyurea parts. The "Extreme" series pump can also be ordered with 50 feet of heated lines and comes standard with either a pole or hand gun. At 303 lbs. this pump is available with either semi-pneumatic tires for operating on hard concrete surfaces or can be ordered with a full set of pneumatic tires for rough off road handling. Additionally the "Condor Extreme" can be special ordered for low-pressure spraying of various elastomeric materials in molds or other types of substrates. Note! This pump is a special order item so please allow 2-3 weeks for delivery. Extreme BT Specifications  Frame: Powder Coated Tubular Steel  Motor: 1 HP DC, 90 Volt with Stainless Steel Hood  Pumps: (2) Stainless Steel Georotor  Electrical Supply: 110 Volt  Controls: Var. Speed Material Flow Dial/Hand Gun or Manual On/Off Switch  Viscosity: 100 To 2500 CPS  Flow Rate: To 1 GPM Continuous Flow Rate  Gauges: (2) Glycerine Filled 1500 psi  Ratio: 1:1, 1:2, 1:3 or 2:3 Quick Change  Supply Line: Teflon Lined, Insulated & Heated, Stainless Steel Braided 3/8" x 25’ Hose Rated at 2500 PSI with Flexible Plastic Scuff Cover  Dispensing Gun: Aluminum, Electrically Operated, Manual On/Off Switch (No-Drip Valve)  Weight: Hand Gun (for low pressure spraying) - 24 ounces, LPS Wand and Tip - 14 ounces, Pole gun Extension (for joint/crack filling) - 48 ounces  Heat Supply: Automatically Controlled, SPST Radiant Heat Coil with Safety Shield  Material Tanks: (2) 7 Gallon Stainless Steel Tanks With Lids  Base: 3/8" Aluminum Plate  Amp Breaker System: When in full use, the electrically heated supply lines and tank heaters draw a minimum of 12 amps. The electric pump motor draws 10 amps. Circuit used must have a 25 amp breaker or the individual power cords for the heater and motor must be plugged into separate circuits.  Wheels: 12" Semi-Pneumatic Rear Tires, 5” Solid Rubber Front Swivel Tires  Heat Range: Material is maintained at a temperature of 125° F to 150° F.  Machine Weight: Approximately 303 lbs. Dry  Packaging: Custom Build Wooden Shipping Crate Standard With All Models